![how to tranfer zbrush model to a new one](https://4.bp.blogspot.com/-Tv1mg3AObkY/VCpXNicD2KI/AAAAAAABObU/2Ch7-LYHwp8/s1600/How%2Bto%2BRender%2BZBrush%2BModels%2Bin%2BKeyshot.jpg)
Adjusting ssao twinmotion
I will check this out. Make sure you are looking level and project all from or else it may pull pull the mesh into the. Zbruwh hope that makes sense. Thanks noe the comments. So i made the changes me to transfer all the change the topology and not. So i tried to use project all and check all over the model to see where the problem areas are and undo the projection and readjust the model to match in those problem areas.
Normally its the other way.